GE CSB9120 Installation Instructions Manual page 11

Preparation
• PSB9120 is the only approved model to be installed under 36-3/4" height with a storage drawer.
CSB9120, ZSC1201 and ZSC1202 are not approved.
• As needed, see the Standard Mount Installation Preparation OR Flush Mount Installation Preparation
for configuration details. Note the modified cutout height below.
• Model ZSC1202 cannot be installed with an accessory storage drawer. See installation preparation
without an accessory storage drawer for this model.
PREPARE THE OPENING (cont.)
The Advantium 120V can be installed in combination with other GE Appliances/Monogram appliances.
Always follow each product's Installation Instructions to complete the installation.
Single Advantium 120V Installation:
Order a 30 wide single oven cabinet or cut the opening in a wall to the dimensions shown.
STANDARD MOUNT
30
25-1/4
Min.
21
36-3/4
Min.
• Allow 2-1/8 case trim overlap on the sides, 1-1/16 overlap on the top and 7/8 overlap on the bottom of
the opening for all models.
• Oven overlaps will conceal cut edges on all sides of the opening.
• When installed over a single oven or a warming drawer, allow at least 2 between the two openings.
This separation will provide clearance for bottom overlap of the Advantium 120V and the other appliance
overlaps.
• The support must be level and rigidly mounted, flush with the bottom edge of the cutout.
Installation Preparation
WITH
23-1/2
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
an Accessory Storage Drawer
FLUSH MOUNT (Monogram only)
22-5/8
36-3/4
Min.
11
23-1/2
K*
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
*See table for desired reveals on sides.
Dimension 1/8"
Reveal
K 30"
1/4"
Reveal
30-1/4"