Table of Contents
Advertisement
E ) FDD/ IDE1/ IDE2 (IDE1 / IDE2 / Floppy Connector)
N ) F_AUDIO (Front Audio Connector)
If you want to use "Front Audio" connector, you must move 5-6,9-10 Jumper. In order to
utilize the front audio header, your chassis must have front audio connector. Also please make
sure the pin assigment on the cable is the same as the pin assigment on the MB header. To find
out if the chassis you are buying support front audio connector, please contact your dealer.
O ) CD_IN (CD Audio Line In)
1
GA-8SIMLFS Motherboard
This Manual: http://www.manuallib.com/file/2596474
1
1
Rear Audio (L)
Rear Audio (R)
POWER
GND
CD-R
GND
CD-L
Important Notice:
Please connect first harddisk to IDE1
and connect CDROM to IDE2.
1
10
9
Front Audio (L)
Reserved
Front Audio (R)
REF
MIC
2
1
L) Battery
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
- 16 -
+
CAUTION
Advertisement
Table of Contents
