Straight Line Adjustment; Handle Bar Adjustment - Graco LineLazer v 3900 Operation Manual

Straight Line Adjustment

The front wheel is set to center the unit and allow the
operator to form straight lines. Over time, the wheel may
become misaligned and will need to be readjusted. To
re-center the front wheel, perform the following steps:
1. Loosen bolt on the front wheel bracket.
2. If striper arcs to the right, loosen left set screw and
tighten right set screw for fine tune adjustment.
3. If striper arcs to the left, loosen right set screw and
tighten left set screw.
3A3388A Operation
4. Roll the striper. Repeat steps 2 and 3 until striper
rolls straight. Tighten bolt on wheel alignment plate
to lock the new wheel setting.

Handle Bar Adjustment

ti27810a
ti27811a
ti27812a
Gun Placement
ti27813a
ti27814a
21