Table of Contents
Advertisement
This Manual: http://www.manuallib.com/file/2597558
H) F_PANEL (2x7 pins jumper)
RS T-
PW+
RST+
PW-
SPK+
1
PD+
PD_G-
SPK-
PD_Y-
1
HD-
HD+
HD (IDE Hard Disk Active LED)
SPK (S peaker Connector)
RST (Reset Sw itch)
PD+/PD_G-/PD_Y-(Power LED) Pin 1: LED anode(+)
PW (Soft Power Connector)
? Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
N) BAT (Battery)
+
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset H ardware System
Pin 2: LED cathode(-)
Pin 3: LED cathode(-)
Open: Normal Operation
Close: Power On/Off
CAUTION
? Danger of explosion if battery is incorrectly
replaced.
? Replace only with the same or equivalent
type recommended by the manufacturer.
? Dispose of used batteries according to the
manufacturer's instructions.
- 19 -
Hardware Installation Process
Advertisement
Table of Contents
