Table of Contents
Advertisement
2.3 Installation of Memory Modules (SO-DIMM)
IMB-186-E provides two 204-pin DDR3 (Double Data Rate 3) SO-DIMM slots.
Step 1.
Align a SO-DIMM on the slot such that the notch on the SO-DIMM
matches the break on the slot.
1. The SO-DIMM only fits in one correct orientation. It will cause permanent damage
to the motherboard and the SO-DIMM if you force the SO-DIMM into the slot at
incorrect orientation.
2. Please do not intermix different voltage SO-DIMMs on this motherboard.
Step 2.
Firmly insert the SO-DIMM into the slot until the retaining clips at both
ends fully snap back in place and the SO-DIMM is properly seated.
12
Advertisement
Table of Contents
