Removing The Warming Drawer; Replacing The Warming Drawer - Bosch HEI8054C Installation Instructions Manual

Removing the Warming Drawer

9 CAUTION
To prevent burns, do not remove drawer while hot.
Be sure the drawer is empty before removing.
1. Pull drawer to fully open position.
2. Press down on the right drawer clip.
3. Lift up on the left drawer clip.
4. Firmly pull the drawer straight out. Retract housing
slides while drawer is removed.
Parts
Housing
1
Drawer
2
Housing slide
3
Drawer rail
4
Right drawer clip
5
Left drawer clip
6
1
3
6

Replacing the Warming Drawer

1. Be sure housing slides are pushed inside housing.
2. Align the drawer rails with the housing slides attached
to the drawer housing.
3. Firmly push the drawer straight into the drawer housing
until the drawer clicks into place. Note: The drawer has
a "push-to-open" operation. Pressing the lower center
front of the drawer causes the drawer to self-open.
9001126425 Rev A
5
2
4
4. Open and close drawer to test operation. Note: If the
drawer will not close, verify that the rails on the drawer
are properly aligned to housing slides and that the rail
release levers are properly positioned.
Testing Operation
Test the Oven
1. Turn on power at the breaker.
2. Test the oven mode.
Select the BAKE mode. See the Use and Care Manual
for detailed operation instructions.
3. Verify that the oven light comes on and the oven begins
to preheat.
4. Test the door lock.
Set the SELF CLEAN mode. Confirm that the door
locks when the lock icon appears in the display.
5. If any of the tests do not result as explained above,
contact Bosch service for assistance. Otherwise,
continue with testing the rangetop burners.
If any of the tests do not result as explained above, contact
Bosch Service for assistance. Otherwise, the installation is
complete at this time.
English 15