Table of Contents
Advertisement
RemotEye III Configuration
This page shows the configurable settings/parameters of the RemotEye III.
RemotEye III Software Revision
This field shows the software revision of RemotEye III.
RemotEye III Hardware (MAC) Address
This field shows the RemotEye III MAC address. MAC address format is 00 E0 D8 XX XX XX.
RemotEye III IP Address
This field allows the administrator to set the IP address of the RemotEye III or to view the current setting (i.e.,
192.168.1.20).
RemotEye III Gateway Address
This field allows the administrator to set the IP address of the gateway or to view the current setting (i.e.,
192.168.1.1). This is used to allow the RemotEye III to communicate to another network. If no gateway is used,
0.0.0.0 can be entered to this field.
RemotEye III Subnet Mask
This field allows the administrator to set the subnet mask of the RemotEye III or to view the current setting (i.e.,
255.255.255.0). This identifies the network address that the RemotEye III belongs too.
RemotEye III Installation Date
This field shows the date the RemotEye was installed.
RemotEye III Install Status
This field notifies to the UPS that an external device is connected to the UPS.
RemotEye III Data Link
This field will display two different possibilities between RemotEye III and the UPS:
•
Link Down: Disconnected
•
Link Up: Connected
RemotEye III Network Link
This field will display two different possibilities between RemotEye III and the Network:
•
Link Down: Disconnected
•
Link Up: Connected
RemotEye III Polling Rate (secs)
This field allows the administrator to set the time interval of the RemotEye III updates that are received from the
UPS.
RemotEye III Baud Rate (bps) (Not avilable for the 4200FA/4300)
This field shows the data transmission rate between the UPS and the RemotEye III.
RemotEye III General Records Logs Frequency (secs)
This field allows the administrator to set the polling time (in seconds) of the Input Voltage, Output Voltage, Output
Load, Battery Voltage, Input Frequency, and the UPS Output Source. The readings will be stored into the UPS
history log. The longer the polling rate the longer the time frame of records.
RemotEye III System Name
This field allows the administrator to set the value in System name that is defined in MIB-II or to view the current
setting. This string also serves as the RemotEye III Client Identifier (CID) in DHCP systems (e.g.
SystemName.tic.toshiba.com)
78
RemotEye III User Manual – 62330-005
Advertisement
Table of Contents
