Panasonic RX-D10 Operating Instructions Manual page 9

2
1
2
3
4
2
MEMORY/
PGM
3
1
2
3
A
FM
1 3 4
1
Indicates auto scan
AM
Listening to radio broadcasts
Listening to broadcast stations which have
not been programmed (Manual tuning)
Preparation: Set [ ] to "TUNER".
Press [BAND] to select "FM" or "AM".
1
Every time you press the button: FM
Press [TUNE MODE] to clear the preset indicator.
2
The unit is set to the manual tuning mode.
Press [–/g] or [f/
3
Adjust the volume.
4
RX-D11 only
When using the remote control
1. Press [BAND] to select "FM" or "AM".
2. Press [–/g] or [f/+] to tune in the station.
Automatic tuning:
This is a simple way of tuning in stations that have not been preset.
+
Keep [–/g] or [f/ ] depressed, and release it when the frequency
display starts to change. A station with good reception is automatically
selected and the selection process then stops.
To stop automatic tuning, press [–/g
Hint
Automatic tuning may stop without a station having been tuned in
when interference is encountered on neighbouring airwaves. In such
a case, tune in a station by tapping [–/g
Using auto scan
RX-D11 only
You can search for a station by listening to all tuned-in stations for 8
seconds each.
Preparation: Set [ ] to "TUNER".
(Only from the remote control)
Press [BAND] to select "FM" or "AM".
Press [AUTO SCAN].
Auto scan starts.
Press [AUTO SCAN] when you find the desired
station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To turn off the unit:
Set [ ] to "TAPE/ ".
If the tape is travelling, press [L/c STOP/EJECT] as well.
Adjusting the antennas A
For FM reception:
Pull out the telescopic antenna and adjust its length and angle for
optimum reception.
For AM reception:
Turn the unit in the direction which gives the best results.
Reference
Radio broadcasts may be hard to receive in a moving vehicle or in a
building because the signal may be weakened. In such cases, use the
unit near a window.
When there is a lot of noise in an FM stereo
broadcast
Reduce the interference by setting the sound to monaural.
Example:
When an FM stereo program is being received;
Press [FM MODE].
" " is displayed.
MONO
To return to stereo reception, repeat the same procedure to turn off
the " " display.
MONO
AM
+
] to tune in the station.
g ] or [f g g g f f / f f
+
] again.
g g g ] or [f g f / f f f
+
].
9
RQT5210