Panasonic DIGA DMR-E75V Operating Instructions Manual page 33

Advanced Operations
11 Partial Erase
[RAM]
The specified parts of the title are erased irretrievably when you
use this procedure.
Check the title carefully before erasing.
[6]
Press [ENTER]
DIRECT NAVIGATOR Partial Erase
at the start point
and end point of
the section you
want to erase.
(l right, "For quicker
editing")
[7]
Select "Exit"
with [3, 4] and
press [ENTER].
[8]
Select "Erase"
with [2] and
press [ENTER].
11 Change Thumbnail
[RAM] [DVD-R]
You can specify an image to be shown as a thumbnail picture in the Title View.
[6]
Press [1, PLAY] to play.
[7]
Press [ENTER] at the point you want to display.
[8] Select "Exit" with [3, 4] and press [ENTER].
≥A scene of display is changed at the point.
∫ To change another point of the same title
After changing the point, select "Change" in step 7 and repeat steps 6–8.
For your reference
≥You cannot select the top and end of the title.
≥Use search and slow-motion to find the points.
11 Divide Title
[RAM]
You can divide a selected title into two.
You must make sure of dividing a title because it cannot be
recovered after the procedure.
[6]
Press [ENTER]
DIRECT NAVIGATOR Divide Title
at the point you
want to divide
the title.
(l above,
"For quicker editing")
≥To change the point to
divide:
- Select "Divide" with
[3, 4] and press [1,
PLAY], and then
repeat step 6–8. (If you rewound to the beginning of the title,
press [:, SKIP].)
[7]
Select "Exit"
with [3, 4] and
press [ENTER].
[8]
Select "Divide"
with [2] and
press [ENTER].
≥The title is divided at
the point.
DVD-RAM
08 PLAY
Start
End
Next
Exit
0:43.21
Start End
- -:- -.- - - -:- -.- -
ENTER
RETURN
Partial Erase
Remaining Time 0 : 58(SP)
Corresponding chapter of PLAY LIST will be erased.
Erase Cancel
SELECT
RETURN
ENTER
DVD-RAM
Preview
08 PLAY
Divide
Exit
0:00.00
Divide
0:00.00
ENTER
RETURN
Divide Title
Once divided, this title cannot be
recombined.
Divide Cancel
SELECT
RETURN
ENTER
∫ To erase another part of the same title
After storing the point in "Start" and "End", select "Next" in step 7 and
perform step 8, then repeat steps 6–8.
For your reference
≥Use search and slow-motion to find the points.
≥You may not be able to specify start and end points within
3 seconds of each other.
≥You cannot specify start and end points if the recorded picture is
stilled.
≥The unit pauses when the title reached to the end during this
procedure.
≥The disc's available recording time may not increase after erasing
short parts of titles.
For quicker editing
≥Use search (l 19), Time Slip (l 19) or slow-motion (l 19) to find
the desired point.
≥Press [:, SKIP] or [9, SKIP] to skip to the start or end of a
title.
DIRECT NAVIGATOR Change Thumbnail
ªTo check the division point
By selecting "Preview" in step 6 and pressing [ENTER], play will
begin from 10 seconds prior to the division point to 10 seconds after
the division point. You can make sure that the division point is
appropriate.
Note
≥A little portion of the recording directly preceding the division point
may be lost.
For your reference
≥The divided titles retain the name of the original title. They also
remain CPRM property (l 15) of the original.
≥Use search and slow-motion to find the points.
≥It is not possible to carry out "Divide Title" in the following cases:
- When the resulting part(s) are extremely short.
- When the total number of titles is more than 99 (DVD-RAM).
DVD
DVD-RAM
08 PLAY
Change
Exit
0:00.00
Change
0:00.00
ENTER
RETURN
33