Starting The Pbx - Panasonic KX-TDE200 Installation Manual

3.13.1 Starting the PBX

3.13 Starting the PBX
3.13.1 Starting the PBX
Before Starting the PBX
Before starting the PBX, please pay attention to the following:
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the IPCMPR card before startup.
Starting the PBX
WARNING
Use only the AC power cord included with the PBX for the PSU.
CAUTION
•
Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing
an earthing strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data is cleared. To restart the PBX, refer
to "5.1.4 Using the Reset Button".
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".
System Initialisation Procedure
1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
170 Installation Manual
RUN Indicator
Reset Button
System Initialise Switch
RESET
SYSTEM
INITIALIZE
NORMAL