Table of Contents
Advertisement
Instructions to Installer
1.
Installer must leave instruction manual with owner after
installation.
3.
Installer should show owner how to start and operate the
combustion air being siphoned from the outside of the building
and all exhaust gases expelled to the outside of the building. The
information contained in this manual pertains to all models and gas
control systems unless otherwise noted.
This unit is not for use with solid fuels.
as a Direct Vent Gas Fireplace and shall be installed according to
these instructions.
Consult your local building code agency, prior to installation, to ensure
compliance with local codes-including permits and inspections.
accordance with local codes or, in absence of local codes, with
the National Electric Code ANSI/NFPA 70, if an external electrical
source is utilized.
These models may be installed in a bedroom or bed-sitting room
in the U.S.A..
Installation and replacement of gas piping, gas utilization equipment
or accessories and repair and servicing of equipment shall be
person or through a representative is engaged in and is responsible for
(a) the installation or replacement of gas piping or (b) the connection,
installation, repair or servicing of equipment, who is experienced in
such work, familiar with all precautions required and has complied
with all the requirements of the authority having jurisdiction.
State of Massachusetts: The installation must be made
Massachusetts.
ANY CHANGE TO THIS FIREPLACE OR ITS CONTROLS
CAN BE DANGEROUS.
poisoning.
Page 4
INTRODUCTION
WARNING
WARNING
The installation must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code ANSI Z223.1/NFPA
54* Natural Gas and Propane Installation Code *Available from the
American National Standards Institute, Inc. 11 West 42nd St., New
York, N.Y. 10036.
Any alteration of the original design, installed other than as
shown in these instructions or use with a type of gas not
shown on the rating plate is the responsibility of the person
and company making the change.
Important
All correspondence should refer to complete Model Number, Serial
Number and type of gas.
High Altitude
United States) it may be necessary to decrease the input rating by
level. However, if the heating value of the gas has been reduced,
this general rule may not apply. Check with Empire Comfort Systems
Preparation
safe when installed in accordance with this Installation Manual.
check glass condition. Do not install unit with damaged, incomplete,
or substitute parts. Read all instructions before starting installation
and follow these instructions carefully during installation to insure
The warranty will be voided by, and the warranter disclaims any
responsibility for the following actions:
Inc.
or approved by manufacturer.
33740-11-0816
Advertisement
Table of Contents
