G. CYCLE COUNTER
To
Read Total Cumulative Times That The Oven Has Been Used:
PAD
1
Open the door and leave it open.
The oven lamp will turn on and "0" will appear.
2
Close the door.
Carry out Step 3 within 60 seconds of closing the door, or the display
will go blank.
3
While pressing Beep Control Button, press Program Entry Button.
+
The display shows the total cumulative number of times the oven has
been used.
BEEP
PROG
Self Diagnostics Failure Code Explanation
This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODE
F01
• Overcooked food.
• Temperature of exhaust air too high.
F03
• Incoming line voltage too high.
This oven is designed to operate
with 208 or 220-240 Volts AC.
F04
• Incoming voltage too low.
F05
• Defective Memory IC.
F33-34
• Defective thermistor circuit.
F44
• Defective control panel.
F81-F84
• Defective relay circuit.
F86-F89
Note: Above codes shown in the display do not indicate all the possible failures on the unit.
How to Operate
INSTRUCTION
CAUSE
- 13 -
WHAT TO DO
• Unplug the appliance to stop beeping.
• Wait for appliance to cool down to reset operation.
• If food ignites, do not open the door.
• If normal operation does not resume, call the service
agent with information of failure code.
• Check line voltage and that voltage adjustment is
matched.
(Refer to page 5 for power source voltage
adjustment.)
Line Volt.
208 V
220-240 V
• If the line voltage is other than 208 or 220-240 V,
consult electrician to check outlet.
• Unplug the appliance and wait more than 1 minute
and reconnect.
• If normal operation does not resume, call the service
agent with information of failure code.
DIGITAL DISPLAY WINDOW
Connetor Color
White
Black