Tubes Are Facing Away From The Main Frame (1 - NordicTrack E10 REAR DRIVE NTEVEL89909.2 User Manual

3. Orient the Front Stabilizer (3) so that the welded

tubes are facing away from the Main Frame (1).

While a second person lifts the front of the Main
Frame (1), attach the Front Stabilizer (3) to the
Main Frame with two M10 x 95mm Screws (100).
4. Identify and orient the Upright (5) and the Top
Cover (27) as shown.
Slide the Top Cover (27) upward onto the
Upright (5).
Then, have a second person hold the Upright (5)
and the Top Cover (27) near the Main Frame (1).
Locate the wire tie in the Upright (5). Tie the
lower end of the wire tie to the Wire Harness
(60). Next, pull the upper end of the wire tie until
the Wire Harness is routed completely through
the Upright.
Tip: To prevent the Wire Harness (60) from
falling into the Upright (5), secure the Wire
Harness with the wire tie.
Tip: Avoid pinching the Wire Harness (60).
Insert the Upright (5) into the Main Frame (1).
Attach the Upright (5) with four M8 x 16mm
Screws (102) and four M8 Split Washers (103);
do not tighten the Screws yet.
3
4
Wire Tie
Wire Tie
60
102
103
7
Welded
100
Tubes
3
1
Avoid pinching the
Wire Harness (60)
5
27
102
103
1
102
103
102