Specify Dhcp Server Settings - TP-Link Archer C20 User Manual

Chapter 10

10. 3. Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of the DHCP Server if necessary,
and you can reserve LAN IP addresses for specified client devices.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Advanced >
¾ To specify the IP address that the router assigns:
1. Make sure that the
2. Enter the starting and ending IP addresses in the
3. Enter other parameters if the ISP offers, the
and is the same as the LAN IP address of the router.
4. Click Save.
¾ To reserve an IP address for a specified client device:
1. Click Add in the Address Reservation
Network > DHCP Server.
Enable DHCP Server
section.
Customize Your Network Settings
checkbox is selected.
IP Address Pool.
Default Gateway is automatically filled
50