Chapter 3 - Configuration; Accessing Settings - Buffalo AirStation WHR-300HP2 User Manual

Chapter 3 - Configuration

Configuration of the AirStation is done from Settings, the web-based configuration GUI. This user manual shows
Settings screens of WHR-600D as example.

Accessing Settings

To configure the AirStation's settings manually, log in to Settings as shown below.
1
Open a browser.
2
Enter the AirStation's LAN-side IP address in the address field and press the enter key.
Notes:
• The AirStation's default LAN-side IP address depends on the mode.
In router mode: 192.168.11.1
In bridge (access point) mode: 192.168.11.100
If the mode switch is set to Auto and the AirStation is in bridge (access point) mode, the AirStation's IP address is
assigned by an external DHCP server.
• If you changed the IP address of the AirStation, then use the new IP address.
3
Enter "admin" for the username and "password" for the password, then click OK.
Note: If you forget your password, hold down the reset button to initialize all settings. Note that all other settings
will also revert to their default values.
12