TANDBERG 880 MXP Basic Use Manuallines page 31

"Standby" and "Do not disturb"
* Access by pressing 'Disconnect' when

Delay standby is used when you want to have your
company logo present will not on a call
- Standby will not activate when showing PC content while
not in a call

Standby is use while not in a call black out in monitors
(VESA Monitor Power Management)

Do Not Disturb is used when you do not any
incoming calls "ringing-in" to your system
Can be use to show local-only presentations uninterrupted
by calls form the outside.
('Do Not Disturb' will prevent any calls form ringing into your system
by placing it in "busy" mode, and can be cleared by pressing any
key on the remote or disconnecting your multisite call)
not in a call
31