Preparation For Disassembly - Compaq PRESARIO 5000 SERIES Maintenance And Service Manual

Compaq Presario Internet PC 5000 Series Computers
PRODUCT DESCRIPTION
REMOVAL AND REPLACEMENT
PROCEDURES

Preparation for Disassembly

Electrostatic
Discharge
To prepare the computer for removal and replacement procedures, complete the following
Service
steps:
Considerations
Preparation for
Disassembly
Serial Number
Side Access Panel
Graphics Card
Expansion Card
(Modem or Network
Card)
1394 Card
Memory Module
Hard Drive
Disk Drive
Removing the Top
Door
Removing the CD
Storage Door
(Lower Front Panel -
Open the CD Storage
Door)
Optical and Mass
TROUBLESHOOTING
JUMPER AND SWITCH
Remove any disk, compact disc, or tape from the computer.
1.
Turn off the computer and any peripheral devices that are connected to the computer.
2.
The computer power switch should be turned off before you disconnect any
CAUTION
cables.
Before doing any work inside your computer, ground yourself by touching a
CAUTION
metal part of the chassis.
Disconnect the power cord from the electrical outlet, and then from the computer.
3.
Disconnect all peripheral device cables from the computer.
4.
Turn the computer over on its side (open side facing up).
5.
During disassembly, label each cable as you remove it. Be sure to note its
IMPORTANT
position and routing.
STORE | PRODUCTS | SERVICES | SUPPORT | CONTACT US | SEARCH
INFORMATION
Removal and Replacement Procedures
ILLUSTRATED PARTS CATALOG
SPECIFICATIONS
United States