Inserting/Removing The Card - Panasonic DMC-fz7 Operating Instructions Manual

Preparation
2 Insert:
3 1 Close the card/battery door.
• Remove the battery after use.
• When a fully charged battery has been
• Do not remove the card or the battery
14
VQT0V63
Downloaded From camera-usermanual.com Panasonic Manuals
Insert the charged battery fully
paying attention to its direction.
Remove:
Slide the lock A to remove the
battery.
2 Slide the release lever in the
direction of the arrow.
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed. (If you insert a battery that is not
sufficiently charged, the length of time that
the clock setting is stored may become
less.) However, the clock setting is
cancelled after this length of time. In this
case, set the clock again. (P19)
while the card is being accessed. The
data may be damaged. (P15)
• Do not remove the battery with the
camera turned on since the settings on
the camera may not be stored properly.
• The supplied battery is designed only
for the camera. Do not use it with any
other equipment.
Inserting/Removing
the Card
• Check that the camera is turned off and
that the lens is retracted.
• Prepare an SD Memory Card (supplied)
or a MultiMediaCard (optional).
• Close the flash.
1 Slide the release lever in the
direction of the arrow and open
the card/battery door.
2 Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals
on the back side of the card.