Installing A Management Module Battery - HP 5400R zl2 Series Nstallation And Getting Started Manual

Installing the HP 5400R zl2 Switches
Installation Procedures

Installing a Management Module Battery

The battery on the management module is used to keep time for the internal
switch clock. The internal clock will not function properly without a battery.
W A R N I N G
■
■
■
Installing a New Battery.
Figure 2-1. Battery location on Management Module
1.
2.
AT T E N T I O N
ll y a danger d'explosion s'il y a remplacement incorrect de la batterie.
Remplacer uniquement avec une batterie du même type ou d'un type
équivalent recommandé par le constructeur.
2-10
The battery requires special handling at end-of-life. The battery
can explode or cause burns if disassembled, charged, or exposed
to water, fire or high temperature. After replacing the battery,
properly dispose of used battery according to instructions.
There is a risk of explosion if the battery is replaced by an
incorrect type. Ensure to replace the battery with the same type.
To avoid shorting of battery, remove and properly dispose of
battery before returning a Management Module for repair.
Insert the new battery with the lettering and the plus "+" sign facing up.
Install the management module into the switch.