Console Port - HP 5400R zl2 Series Nstallation And Getting Started Manual

For 10/100/1000BASE-T, SFP and SFP+ Ports:
• Off = 10 Mbps or 100 Mbps
• Flashing = 1 Gbps
• On = >1Gbps
For HP Smart Rate ports:
• Off = Not linked
• Slow Flash = 1 Gbps
• Double Flash = 2.5 Gbps
• Triple Flash = 5 Gbps
• On = 10 Gbps
For QSFP+ ports:
• Off = Not linked
• Fast Flash = 40 Gbps
For more information on HP Smart Rate port LEDs and 40G ports in speed
mode, see HP Switch v3 zl2 module installation guide.
PoE
■ If the PoE indicator LED is lit, the Link and Mode LEDs indicate PoE
status:
Link LED:
• On = PoE is enabled on this port
• Off = PoE is disabled on this port.
• Slow Blinking Orange = Internal PoE fault on this port.
• Fast Blinking Orange = This port is denied PoE power or has an
external load fault.
Mode LED:
• On = PoE power is be supplied on this port
• Off = PoE is not being supplied on this port.

Console Port

There are two console ports on the switch. These ports are used to connect a
console to the switch. The one port uses the serial cable supplied with the
switch and the other port uses a MicroUSB cable which is not supplied with
the switch. This connection is described under "Connecting a Console to the
Switch" in chapter 2, "Installing the 5400R zl2 Switches". The console is a full-
featured interface that can be used to configure, monitor, and troubleshoot
the switch. It can be run on a PC, laptop, or handheld device emulating a VT-
100 terminal, or on a standard VT-100 terminal.
Introducing the HP 5400R zl2 Switches
Front of the Switch
1-15