Connecting The Ac Adaptor; Switch Tv On; Auto Set Up - Panasonic TX-22LT2 Operating Instructions Manual

Quick start Guide

2. Connecting the AC Adaptor

3
1

3. Switch TV ON

Power-Indicator
The RED LED when lit indicates that not
only the TV set is in stand-by mode but
also the external AC adaptor is still on.

4. Auto set up

AUTO SETUP IN PROGRESS
SEARCHING:PLEASE WAIT
21
SETUP : Return to tuning menu
TV/AV : To exit
2
68
First, ensure that the VCR is in Stand-by mode.
1 Connect the mains lead to the AC Adaptor.
2 Connect the AC Adaptor DC plug to the DC IN socket.
3 Plug into household mains socket.
• Be sure to use the power cord and AC
adaptor included in the accessories.
• Do not use the AC adaptor for other than
the specified equipment.
• Unplug the AC adaptor if it is not used for
long time.
• Do not place any objects on the AC adaptor.
• Do not use the AC adaptor outdoors.
• Do not attempt to repair the AC adaptor if it
is broken or malfunctioning. Refer the
servicing to the service representative.
• Do not try to open the AC adaptor.
• Do not use water or wet cloth for cleaning
the AC adaptor.
Press the
turn the set on.
There are two ways to switch the TV set to
stand-by mode.
(A) Press the
and check RED LED is lit.
(B) Press the
remote control.
The TV set cannot be switched on by the remote
controller if it was switched to stand-by using
method (A) or vice versa if method (B) was used.
When programme number up ( )/down ( )
buttons on the side panel of the main part
are pressed in stand-by mode, TV turns on.
Programmes will appear immediately if your dealer has
programmed the TV for you.
If the TV has not been programmed for you then Auto setup
will begin, your stations will be located, sorted into order and
stored ready for use.
switch on the LCD TV to
IMPORTANT NOTES
switch on the LCD TV
OR
Stand-by button on the
9