Identifying The Activation Key For The Ilo4 License; Ilo And Bios Configuration After Replacing The Motherboard; Configuring Ilo And Rbsu Settings - HP StoreOnce 4900 Service And Maintenance Manual

Table 3 DIMM slot locations
Model
HPE StoreOnce 4900 Backup
HPE StoreOnce 2900 Backup
The locations of DIMM slots are also shown on the StoreOnce hood label inside the server.

Identifying the Activation Key for the iLO4 license

All products are shipped with paper copies of the iLO4 licenses. If you no longer have these
licenses and the board is still working for the iLO4 GUI connection via its management Ethernet
port, make a note of the license before you remove the motherboard. (If it is not working, contact
HPE Support.)
Before replacing the motherboard, to identify the Activation key:
1. Log on to the iLO4 GUI.
2. Select the Administration Tab.
3. Select Licensing and make a note of the Activation Key.

iLO and BIOS configuration after replacing the motherboard

Configure the RBSU (ROM-Based Setup Utility) settings BEFORE connecting the FC, network,
and SAS cables to the server and BEFORE the system boots into the StoreOnce software, that
is, during the server POST sequence.

Configuring iLO and RBSU settings

After replacing the motherboard, for all products you must:
1. Boot the system. During the POST phase, when prompted, press F8 to perform iLO
configuration, as described in
2. To enter the RBSU (ROM-based Setup Utility) or BIOS Setup to change settings: when the
press F9 prompt appears during the system BIOS boot process, press the F9 key.
3. Change the RBSU settings, as described in
and exit.
4. Let the operating system complete its boot.
5. Check that an existing iLO4 Advanced license is loaded. If it is not, add it:
1. Log on to the iLO4 GUI.
2. Select the Administration Tab.
3. Select Licensing and enter the recorded license key in the section marked Enter
License Activation Key.
6. Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component
is correct.
NOTE:
or a cold reboot to install the new firmware revision successfully.
7. After power-up, it is necessary to rewrite warranty serial numbers into BIOS. Contact HPE
Support for assistance in rewriting warranty serial numbers. Once this task has been done,
use the Rescan button on the Remote Support page of the StoreOnce GUI to view the
warranty details. (Or use the StoreOnce CLI command, system scan devices.)
Processor
1
2
1
2
iLO4 settings (page
Note the output at command completion. It will advise if you need a system reboot
Slots
1,2,4,5,8,9,11,12
1,2,4,5,8,9,11,12
12,9,1
12,9,1
18). Save the changes and exit.
RBSU settings (page 18). Save the changes
Identifying the Activation Key for the iLO4 license 17