Storing A New Configuration; Loading A Configuration - JDS Uniphase HST-3000 User Manual

Storing a new
configuration
Loading a
configuration
The Config Store menu appears.
After you have finished configuring the HST-3000 for a partic-
ular test, you can store the test configuration for future use.
The configurations are stored on power down.
To store a test configuration
1 Set up the HST-3000 for the test you are performing.
2 Press the Configure navigation key.
3 Press the Storage soft key.
4 Press the 2 key.
5 Enter the file name.
6 Press the OK key.
The test configuration is stored.
After a configuration is saved, you can load it. This could save
you some time in cases where the majority of settings are the
same.
To load a test configuration
1 Press the Configure navigation key.
2 Press the Storage soft key.
HST-3000 Frame Relay Testing User's Guide
Chapter 2 Frame Relay Testing
Managing test configurations
21