Pioneer XR-A550MD Service Manual page 88

XR-A550MD
QQ
3 7 63 1515 0
11. EJECT Mode
Step No. Setting Method
Step 1 Test Mode EJECT status
Step 2 Press the DELETE button.
Step 3 Press the DELETE button.
Step 4 Press the DELETE button.
Step 5 Press the ENTER button.
Step 6 Press the DISP/CHARA button.
Read-IN Switch Position Measurement Mode
NOTE) Adjust the read-in switch position to 5F FF85 to FFD2.
1. Loosen the three screws (A) securing the MD MECHA SW
ASSY.
2. While pressing the MD MECHA SW ASSY in the + direction,
tighten the screws, and measure the read in switch position
again. After adjusting the position, secure the three screws (A).
Loosen the Three Screws (A)
TE
L 13942296513
MD MECHA SW ASSY
Fig.3
Loading Motor Forced Rotation
When Test Mode STOP status and EJECT status are displayed, the
loading motor can be forcefully rotated by pressing the ¡/1
buttons.
www
.
88
http://www.xiaoyu163.com
Maximum power output status
Recording power output status
Playback power output status
To EEPROM setting TEMP setting
(Refer to EEPROM setting TEMP setting.)
To EEPROM setting CONTROL setting
(Refer to EEPROM setting CONTROL setting.)
Read in Switch
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Remarks
Q Q
3 6 7 1 3 1 5
co
.
9 4 2 8
Display
[ _ _ EJECT_ _ _ ]
[ xpw_ _ _ _ _ _ _ ]
[ rpw_ _ _ _ _ _ _ ]
[ ppw_ _ _ _ _ _ _ ]
0 5 8 2 9 9 4 2 8
m
9 9
9 9