Panasonic TC-P54Z1 Quick Start Manual page 10

Accessories/Optional Accessory
Warning
Do not disassemble or modify the pedestal.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any other TV and displays.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic
Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be
strong enough to support the TV, and it might fall over and become damaged, and personal injury may result.
Fix the Mounting bracket securely to the back of the Display unit with
Assembly screws
Insert the speaker mounting screws
holes of the speaker and fix the speaker mounting screws
mounting bracket.
Orient the front side of the Mounting bracket toward the rear side of the
speaker and Display Unit side.
Fix it same as the speaker at the other side.
There will be a gap between the Display Unit and the speaker.
Back of
Display Unit
Mounting
bracket
[Lower right]
Connect Display Unit and speaker with speaker cable.
Fix it in the same way as the speaker on the other side.
Speaker
To open the Clamper
Hook
Note
Tighten the screws firmly.
Insert to the end of the speaker cable terminal firmly.
Loosen the screw shown in fig.
Do not hold the speaker to transport the unit.
10
Attaching the pedestal to TV (continued)
Attaching the pedestal to TV
Attaching the Speaker to TV
.
temporarily in the screw outermost
Place the temporarily inserted screws
into the counter sunk holes
on the bracket
Mounting bracket
[Top]
Speaker
Assembly
screws
Lower right
(Back of Display Unit)
Speaker
cable
Press the part and
remove the hook.
A above to adjust the gap between the speaker and the Display Unit.
to the speaker
Back of
Display Unit
Assembly
screws
Connect the terminal
near the ferrite core to
the Display Unit.
Accessories
Speaker (2)
SP-54Z1U
Mounting bracket
[Top] (2)
TXFKR04DLUJ
Front Back
[Lower right] (1)
TXFKR05DLUJ
Front Back
[Lower left] (1)
TXFKR06DLUJ
Front Back
Assembly screws
TXFXY01DLUJB
(8) (8)
Speaker cable (2)
TXJ/SPDKUU-1