Table of Contents
Advertisement
Chapter 4 Adjustments and settings for recording
Display item
E AUDIO input
system and level
meter
F Super black ON
G Super iris ON
H Iris override
display
I Iris, f-value
J Zoom display
K Interval, pre-rec
display
(Jump indication)
L Dynamic range
stretcher mode
M Compression
mode
54
Downloaded From CamcorderManual.com Panasonic Manuals
What is displayed
---- ---+
∫
F
W
R
B
S
++
+
(No display)
–
– –
NC
OPEN
F1.7 to F16
CLOSE
Z00 to Z99
i (flashing)
iREC (lighting)
iREC (flashing) ¢¢h¢¢m/¢¢s
P-REC (flashing) ¢s
TAPE ¢s
JUMP (flashing)
DRS
COMP
Status when display appears
This indicates the audio channels selected and their audio levels.
This appears when the AUDIO IN switch is at the FRONT position.
This appears when the AUDIO IN switch is at the WIRELESS position.
This appears when the AUDIO IN switch is at the REAR position.
This appears when S.BLK has been set to ON.
This appears when S.IRIS has been set to ON.
When the iris override function is working, this indicates how much
compensation is provided.
++:
The aperture is opened by a full stop.
+:
The aperture is opened by a half stop.
– –:
The aperture is closed by a full stop.
–:
The aperture is closed by a half stop.
No display: Reference status
This appears when the lens cable is not connected.
This appears when the lens aperture is open.
This indicates the aperture value (f-value) of the lens.
This appears when the lens aperture is closed.
<Note>
These displays appear when using a lens equipped with an aperture
value display function.
They flash while the aperture is being
changed for the iris override.
This indicates the amount of zoom. Note that this item is not displayed
even if the display setting is ON if the lens is not equipped with a
zoom position return function.
This appears in the INTERVAL REC mode during the times when the
operation of the REC button is not acknowledged before the start of or
at the end of recording.
This appears during an INTERVAL REC operation.
This appears during INTERVAL REC standby to indicate the wait time
until the next recording.
This indicates the amount of time remaining until the end of the set
PRE REC time during PRE REC operation.
This appears when recording is stopped by turning OFF the PRE
REC MODE (in the state where signals accumulated in the built-in
memory are recorded on tape).
This appears during the jump function.
This appears when the video level of a part with high brightness is
compressed, and the function stretching the dynamic range is
selected.
This appears when setting the mode for suppressing distortion of
compressed video images that may occur when dark parts are shot.
(continued)
Advertisement
Table of Contents
