Table of Contents
Advertisement
2. INSTALLATION
2-1. Installation of the sewing machine
1)
Carry the sewing machine with two persons as
shown in the figure.
❷
❶
2-2. Attaching the belt cover
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
A
❷
Securely attach two belt cover studs ❶ to the screw holes in the machine arm.
1)
Put setscrews ❸ in hole A of belt cover A ❷ and section B, and fix them with setscrew washers ❹.
2)
Attach belt cover A ❷ to the machine arm from the slanted rear side so that it covers the belt.
3)
❶
❹
B
❼
– 4 –
❶
22.5 mm
❷
A
2)
Attaching the oil pan
Hammer the nails ❷ on the two support rubber
seats ❶ of the machine head on operators' side
A of the protruding section of the table, and fix
the two cushion seats ❸ of the machine head on
hinging side B with rubber adhesive agent. Now,
put the oil pan ❹ on the cushions.
3)
Attaching the hinge
Fit the hinge ❶ in the hole in the bed and engage
it with the rubber hinge ❷ of the table. Put the
machine head down on the cushions located at
the four corners.
❾
❽
C
❸
❻
❺
❹
18.5 mm
❸
B
❼
Hide quick links:
Advertisement
Table of Contents
