Preparation/Mounting - Dual DV271BT Installation & Owner's Manual

DV271BT
Preparation
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it
would be subject to dust, dirt or excessive vibration.
Getting Started
• Insert the supplied keys into the slots as shown.
• Connect wiring harness as shown on page 6. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
• Reconnect negative battery terminal, and test for correct operation.
• Snap trim ring into place (if required).
Mounting sleeve opening dimensions
7-3/16" x 2-1/16" (183 mm x 53 mm)
5
INSTALLATION
TRIM PLATE
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
TAPTITE TRUSS HEAD 5X6MM
TAPTITE BINDING HEAD 5X6MM
UNIT