Kenwood KDC-348U Service Manual page 14

KDC-348U/4751SD/BT41U/BT648U
/U4549/U4549SD/U549BT/X395/X695
3) Status display during adjustment
Status
Adjustment success
A
Adjustment failure
A
4) Operation of return to TUNER Test Mode
Operation
RETURN Mode release
BAND switch list
Type BAND1
K qFM1
E qFM1
M qFM1
● CD Test Mode Specifi cation
It shall be the same as normal RST start in other than the below setting.
Playback track from top
Default for Display mode
Operations in CDDA playback
Operation
Special track
up
Special track
down
Special jump
3
operation
Special jump
4
operation
Special jump
5
operation
Special jump
6
operation
● BT test mode specifi cation (BT built-in model)
Initial condition of the BT MODE (BT source) will display as following.
Status
BT MODE
14
TEST MODE
Display content
D J O K
D J N G
Display content
BAND2 BAND3
FM2 FM3
FM2 FM3
FM2 FM3
Content
Display content
Display content
B T M O D E
When the adjustment value write-in to E2PROM (IC203 on X34)
: x x
has been completed. xx: Level offset value (HEX)
When the adjustment value write-in to E2PROM (IC203 on X34)
has failed
Return to TUNER Test Mode.
BAND4 BAND5
wAM -
wMW/LW -
wMW SW1
No.9
Play time
Every time pressed, track up/down performed as below.
No.9→No.15→No.10→No.22→No.12→No.13→No.14→No.9
However, playback is from No.1 for discs with 8 tracks or
less.
If transferred to tracks other than the above with B. Skip,
up/down is performed 1 track at a time to the nearest track
Jump to No.28
(Scratch 0.7mm for MUSIC line vibration test)
Jump to No.14 (Damaged disc TCD-731RA Tr14)
Jump to No.15
• Set Volume value at 27 (2.5V PREOUT MODEL)
• Set Volume value at 29 (4V PREOUT MODEL)
(for error operation FCT check of 20Hz 0dB DC protection)
Jump to No.9 if the track No.22 is playing.
Jump to No.22 if the track No.9 is playing.
BT MODE display
Details
Details
BAND6 Details
- q→w
- q→w
SW2 q→w
Details
Details
Details