Advertisement
DASH MOUNTED LED
2PIN White Plug w/2 Wires; Red and Blue
The Red and Blue wires in the 2PIN mini white connector control the anode and cathode of the dash mounted
LED. Route the twin lead Red and Blue wires from the LED to the control unit and plug the two pin connector into
the mating white mini connector shell of the control module. Do not force the connector, it will only plug in one way.
VALET/PROGRAM/MANUAL OVERRIDE SWITCH
2PIN Blue Plug w/2 Wires; Black and Gray
The Black and Gray wires in the 2PIN blue connector are the ground supply and Valet/Program input of the unit.
When the Gray wire is grounded, under certain conditions, the unit will enter the valet mode. When the Gray wire
is sequentially grounded under other conditions, the unit will enter the various program modes. Route the Black
and Grey wires from the Valet/Program/Manual Override switch to the unit and plug the blue 2PIN connector into
the mating blue connector shell of the control module. Do not force the connector, it will only plug in one way. Note:
Please refer to the section; "Programming System Features" shown later in this installation guide to learn the
operation of the valet/program/manual override switch.
POWER DOOR LOCK HARNESS
3PIN White Plug w/3 Wires; Red, Green, and Red/Black
The connection of the power door lock/unlock wires has already been explained. Route the Red, Green, and Red/
Red/Black wires to the unit and plug the white 3PIN connector into the mating white three pin connector shell of
the control module. Do not force the connector, it will only plug in one way.
PROGRAMMING FEATURES:
There are seven (7) Programmable Features on the system. Study the list below, keeping in mind the features
and their defaults, (how it comes programmed from the factory) and decide how best to program the UNIT for your
particular installation.
Programmable Features:
Features
1 Chirp
First
Passive Arming
Second
Ignition D/L ON
Third
Ignition D/UL ON
Fourth
Chirps ON
Fifth
Passive D/L
Sixth
Siren Output
Seventh
800ms D/L Pulse
To Program These Features:
Entering the Programming Mode involves operating the Ignition Switch and the Valet/Program/Manual Override
Switch in a particular sequence. This sequence is very time dependent, in other words it must be performed
quickly in order for you to enter the mode. This sequence is also only one step different from the Transmitter
Programming Mode, so make certain you perform the sequence properly.
Upon entering the Programming Mode, the system is immediately set to allow adjustment of the First
Programmable Feature. That First feature, "Passive or Active Arming", can then be set ON or OFF by pressing
button 1 of the transmitter. The system confirms that it is set to adjust the First feature by repeatedly flashing the
LED once, with a pause in between each flash. The system will then report how the feature has been set by the
number of chirps heard after pressing the transmitter button. Toggling the Valet/Program/Manual Override Switch
once again will advance you to the Second Programmable Feature, confirmed by a repeating two LED flashes,
with a pause in between each flash, etc., etc.
2 Chirp
Active Arming
Ignition D/L OFF
Ignition D/UL OFF
Chirps OFF
Active D/L
Horn Output
3.5 Sec. D/L Pulse
800ms D/L Pulse
Double 800ms D/UL Pulses
5
3 Chirps
Active Arming
Ignition D/L OFF
Ignition D/UL OFF
Chirps ON
Active D/L
Horn Output
800ms Door Lock
Default
Advertisement
