Table of Contents
Advertisement
12. Help
Problem
The printing quality is
poor.
12.3.7 Answering machine
Problem
The answering machine is
turned ON, but caller
messages are not
recorded.
I cannot operate the
answering machine with
the cordless handset.
I cannot retrieve recorded
messages from a remote
location.
The other party complains
that they cannot leave a
voice message.
While recording a
greeting message or
listening to messages, the
unit rings and recording
stops.
12.3.8 If a power failure occurs
L The unit will not function.
L The unit is not designed for making emergency telephone calls when the power fails. Alternative
arrangements should be made for access to emergency services.
L Fax transmission and reception will be interrupted.
L If delayed transmission (feature #25 on page 67) is programmed and power failure prevents the
document from being sent at the set time, the document will be sent after power is restored.
L If any fax documents are stored in the memory, they will be lost. When power is restored, a power
down report will be printed stating which documents in memory have been erased.
98
Cause & Solution
Please do not reuse the ink film!
Please use genuine Panasonic replacement film. Refer to page 11 for
further details.
Original
A BC
L Some paper has instructions recommending which side to print on.
Try turning the paper over.
L You may have used paper with a cotton and/or fibre content that is
over 20%, such as letterhead or resume paper.
L The thermal head is dirty. Clean it (page 105).
Cause & Solution
L The recording time is set to "GREETING ONLY". Select "1
MINUTE" or "NO LIMIT" (page 61, or feature #10 on page 66).
L The message memory is full. Erase unnecessary messages (page
58, 60).
L Another user is using the answering machine, accessing the Caller
ID list or on an outside call. Wait for the other user to finish.
L Another cordless handset user is changing program using the
base unit PIN (page 78). Wait for the other user to finish.
L A caller is leaving a message. Wait for the caller to finish.
L The cordless handset is too far from the base unit. Move closer.
L Activate the remote operation feature by setting the remote
operation ID beforehand (page 61, or feature #11 on page 66).
L Press the remote operation ID correctly and firmly (page 63).
L The unit is not in TAM/FAX mode. Change to TAM/FAX mode (page
50).
L The memory is full. Erase unnecessary messages (page 58, 60).
L The recording time is set to "GREETING ONLY"/"Greeting
Only". Select "1 MINUTE"/"1 Minute" or "NO LIMIT"/"No
Limit" (page 61, or feature #10 on page 66).
L A call is being received. Answer the call and try again later.
Copy
Advertisement
Table of Contents
