Setup; Power Supply; Charging The Battery - Panasonic VDR-D160GN Operating Instructions Manual

Setup

Power supply

Power supply

Charging the battery

When this unit is purchased, the battery is not charged. Charge the battery before using this unit.
1 Connect the AC cable to the AC adaptor and the
AC outlet.
2 Put the battery on the battery mount by aligning
the mark, and then securely plug it in.
≥ The output plug of the AC cable is not completely connected to the
AC adaptor socket. As shown in A, there is a gap.
∫ Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up
and normal charging will start.
When the battery temperature is excessively high or low, the CHARGE lamp flashes and
the charging time will be longer than normal.
≥ Battery charging time (l 20)
≥ We recommend using Panasonic batteries. (l 8)
≥ If you use other batteries, we cannot guarantee the
quality of this product.
18
LSQT1184
≥ If the DC cable is connected to the AC adaptor, then
the battery will not charge. Remove the DC cable
from the AC adaptor.
A