I/O Module Blank - HP D6000 Disk Enclosure Maintenance And Service Manual

Release the I/O handle, push the I/O handle down until it ejects the I/O module, and then remove the
3.
I/O module.
CAUTION:
more than one component or blank removed. When removing an active component permanently,
replace it with a blank.
To replace the component, reverse the removal procedure. Be sure the I/O module is fully seated and the I/O
module handle is in the locked position.

I/O module blank

CAUTION:
more than one component or blank removed. When removing an active component permanently,
replace it with a blank.
For best cooling practices, do not operate the enclosure for extended periods with
For best cooling practices, do not operate the enclosure for extended periods with
Removal and replacement procedures 26