Philips TCM2.0E Service Manual page 10

EN 10 4. TCM2.0E LA
Figure 4-8 Speaker and IR/LED panel cable release
4.3.3 Keyboard Control Board
1. Refer to next figure.
2. Unscrew two screws[1]
3. Unplug connector [2] and remove the board.
When defective, replace the whole unit
Figure 4-9 Keyboard control board
4.3.4 IR/LED Board and Speakers
1. Refer to next figure.
2. Remove the screws [1] and remove the IR/LED board.
3. Remove the screws [2] and remove the speakers.
When defective, replace the whole unit.
Mechanical Instructions
4
4
4
I_17930_042.eps
240408
1
2
1
I_17930_063.eps
240408
2
1 1
Figure 4-10 IR/LED Board and Speakers
4.3.5 Power Supply Board
Due to different set executions this chassis is supplied with one
or two power supply boards and figures may differ.
Caution: it is absolutely mandatory to remount all different
screws and cables at their original position during re-assembly.
Failure to do so may result in damaging the power supply.
1. Refer to next figure.
2. Unplug all the connectors [1].
3. Remove the fixation screws [2]
4. Remove the main power supply board.
5. Unplug all the connectors [3].
6. Remove the fixation screws [4]
7. Remove the stand-by power supply board.
2
2
Figure 4-11 Power Supply Unit(s)
2 2 2
I_17930_043.eps
2
1
4
3
1
2
4
I_17950_006.eps
240408
4
4
080508