Panasonic WV-CLR920A Operating Instructions Manual page 10

q Auto Iris Lens Connector
This connector is used to connect the auto iris lens
with a 4-pin male connector supplied as a standard
accessory (Part No. YFE4191J100).
w Flange-back Adjusting Ring (FB)
This ring is used to adjust the back focal length or
picture focus. Rotate this ring upward or downward
for a CS-mount lens. In case of using a C-mount
lens, adjust it with the C-mount adapter.
e Lens (Option)
r Focus Fixing Screw (LOCK)
t Camera Mounting Screw Hole
This hole is used to mount the camera onto a
mounting bracket.
y Down Button (K)
This button is used to move the cursor downward. It
is also used to select items in the CAM SET UP
menu.
u Right Button (M)
This button is used to move the cursor to the right.
It is also used to select the mode and can be used
to adjust some levels.
i Left Button (L)
This button is used to move the cursor to the left. It
is also used to select the mode and can be used to
adjust some levels.
o Up Button (J)
This button is used to move the cursor upward. It is
also used to select items in the CAM SET UP menu.
!0 Set Button (I)
This button is used to activate an item selected in
the CAM SET UP menu.
!1 Gen-lock Termination Switch (Hi-Z, G/L 75Ω)
Set this switch to Hi-Z when a gen-lock video input
signal is looped through. In all other cases, set this
switch to 75 Ω.
!2 RS-485 Termination Switch (Hi-Z, RS485 LINE
TERM)
This switch is used to terminate of the RS485 termi-
nal. Normally keep it LINE TERM position.
!3 Full duplex/Half duplex Selection Switches
(4-LINE/2-LINE)
These triple switches are used to select either full
duplex (left side) or half duplex (right side) for the
communication lines.
-10-