Panasonic Lumix DMC-LS80 Operating Instructions Manual page 104

LCD
■
Conditions
The LCD monitor
sometimes turns off
although the camera is
turned on.
The brightness of the
LCD monitor becomes
dark or bright for a
moment.
The LCD monitor
flickers indoors.
The LCD monitor is too
bright or dark.
Black, red, blue and
green dots appear on
the LCD monitor.
Noise appears on the
LCD monitor.
Flash
■
Conditions
Flash is not activated.
The flash is activated 2
times.
Others
The LCD turns off immediately after using the flash while it
recharges.
The LCD may turn off immediately after setting to recording
mode while it recharges.
Have you set [AUTO LCD OFF]?
This phenomenon appears when pressing the shutter button
halfway to set the aperture value and does not affect the
recorded pictures.
The LCD monitor may flicker for a few seconds after turning
the camera on indoors under fluorescent light.
This is not a malfunction.
Adjust the brightness of the LCD monitor.
Is the power LCD or the high angle mode activated?
This is not a malfunction.
These pixels do not affect the recorded pictures.
In dark places, noise may appear to maintain the brightness
of the LCD monitor. This does not affect the pictures you are
recording.
Is the flash setting set to Forced OFF [
Change the flash setting.
The flash is not activated when motion picture mode [
[SCENERY], [NIGHT SCENERY], [SUNSET], [HI-SPEED
BURST], [STARRY SKY], [FIREWORKS] and [AERIAL
PHOTO] mode, burst and auto bracket is selected.
When you select red-eye reduction (P39), the flash is
activated once before the actual recording to reduce the red-
eye phenomenon (eyes of the subject appearing red in the
picture) and then activated again for the actual recording.
- 10 -
Causes
(P22)
(P21)
Causes
v ]?
(P39)
(P38)
i
],