R720 & R820 Power Vent Indoor Gas Fireplace
Section 3-5: Heat Shields
Installing a Wall Mounted RHS102 Heat shield
The RHS102 Heat shield must be used if vent pipe passes through
a wall or ceiling within 6' of the unit�
To install the RHS102, Slide the Inner Section over the vent pipe
that will connect to the fireplace. Then fasten the vent pipe to the
back of the fireplace with a minimum of three sheet metal screws.
From the outside slide the RHS102 outer section on� To complete
the installation fasten the Heat Shield Outer Section & inner section
to the structure� See Figure 14.
½" Min .
Figure 14. RHS102 Installation. (Install by sliding over
vent pipe where it passes through the combustible
construction).
Page 22
Installation
½ " Min. Both sides Typical
Inner Shield 11 1/3"
Outer Shield 11 1/2"
Combustible Framing
XG0772 - 150105�4