Electrical Requirements; Water Supply Requirements - Jenn-Air JS42SSDUDE Installation Manual

The water shutoff should be located in the base cabinet on
either side of the refrigerator or some other easily accessible
area. If the water shutoff valve is not in the cabinets, the
plumbing for the water line can come through the floor or
the back wall. See "Water Supply Requirements" for more
information.
80" - 90"
(203-229 cm)
¹⁄₂
83 " (212.1 cm) min.
³⁄₄
84 " (215 cm) max.
to bottom of solid soffit
(see chart following)
6"
(15.2 cm)
24"
(60.96 cm) min.
Width A
Model (as shown above)
42 41¹⁄₂" to 41³⁄₄"
(105.4 cm to 106.1 cm)
48 47¹⁄₂" to 47³⁄₄"
(120.7 cm to 121.3 cm)
NOTE: Flooring under refrigerator must be at same level as the
room. Face of cabinetry must be plumb.
6
B
Dimension
77"
(196 cm)
A
Width
6"
(15.2 cm)
1"
(2.54 cm) 6"
(15.2 cm)
Dimension B
(as shown above)
7¹⁄₂"
(19.1 cm)
13¹⁄₂"
(34.3 cm)

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
IMPORTANT: If this product is connected to a GFCI (Ground Fault
Circuit Interrupter) protected outlet, nuisance tripping of the power
supply may occur, resulting in loss of cooling. Food quality and
flavor may be affected. If nuisance tripping has occurred, and if
the condition of the food appears poor, dispose of it.
NOTE: Before performing any type of installation or cleaning,
remove the top grille and turn the master power switch to OFF
or disconnect power at the circuit breaker box.
When you are finished, turn ON the master power switch or
reconnect power at the circuit breaker box. Then reset the
control to the desired setting.

Water Supply Requirements

All installations must meet local plumbing code requirements.
The water shutoff should be located in the base cabinet on
either side of the refrigerator or some other easily accessible
area. The right-hand side is recommended. The access hole
through the cabinet must be within ¹⁄₂" (1.3 cm) of the rear wall.
NOTE: If the water shutoff valve is in the back wall behind the
refrigerator, it must be at an angle so that the tube is not kinked
when the refrigerator is pushed into its final location.
6"
(15.2 cm)
24"
(60.96 cm) min.
6"
(15.2 cm)
1"
6"
(2.54 cm)
(15.2 cm)