Using The Battery; Power Supply; Using The Ac Adaptor - Panasonic NV-GS70B Operating Instructions Manual

≥The above operative ranges are for indoor use.
Outdoors or under strong light, the Movie
Camera may not operate properly even within
the above ranges.
≥Within a 1-metre range, you can also use the
Remote Controller on the LCD Monitor side of
the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated individually
by selecting different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS]
Sub-Menu to the desired Remote Controller
Mode. ( )
-17-
Setup on the Remote Controller:
6
STILL ADV
2
E
INDEX
K
SELECT
[VCR1]:
Press the [D] Button and [∫] Button
simultaneously. 1
[VCR2]:
Press the [E] Button and [∫] Button
simultaneously. 2
≥When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.

Power Supply

ª Using the AC Adaptor
1
Connect the DC Input Lead to the Movie
Camera.
2
Connect the DC Input Lead to the AC
Adaptor.
T
W
1 5
PAUSE STILL ADV
1
; D
STOP INDEX
L
∫
1
Before Use
3
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥The AC Mains Lead's outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown 1.
≥Before connecting or disconnecting the
power supply, set the [OFF/ON/MODE]
Switch on the Movie Camera to [OFF] and
make sure that [CAMERA/VCR/CARD PB]
Lamps are not lit.
ª Using the Battery
Before use, fully charge the Battery.
1
Attach the Battery to the AC Adaptor and
charge it.
≥Since the Battery will not be charged when
the DC Input Lead is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥The [POWER] Lamp and [CHARGE] Lamp
lights up, and charging starts.
≥When the [CHARGE] Lamp goes off,
charging is completed.
2
Attach the charged Battery to the Movie
Camera.
Disconnecting the Power Source
Set the [OFF/ON/MODE] Switch
and, while pressing the [PUSH BATT] Button
(52)
, slide the Battery or DC Input Lead upward to
disconnect it.
(52)
(49)
≥For other notes concerning this item, see
-11-
(49)
PUSH
BATT
to [OFF]
.
-58-