Multi-Unit Operation - Panasonic KX-TGA715E Operating Instructions Manual

TGA715E_717E(e-e).book Page 15 Wednesday, August 2, 2006 2:46 PM
Feature
Erasing all entries

Multi-unit operation

Feature
Intercom: calling
Intercom: answering
Transferring calls between
handsets
*1
Conference calls
(2 people can have a
conference call with an outside
party)
Manual registration
Cancelling a handset
*1 KX-TG7100 does not support conference call feature.
*2 After pressing {x}, the rest of this procedure must be completed within 1 minute.
*3 If you forget the base unit PIN, consult your nearest Panasonic service centre.
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Operation
{j/OK} i "Caller List" i {>} i {j/OK}
"Erase All" i {>} i "Yes" i {>} i {ih}
Operation
Example: When you call handset 1
{INT} i Press {1} (desired handset number).
L When finished talking, press {ih}.
Press {C}/{s}.
L When finished talking, press {ih}.
Example: When you transfer a call to handset 1
During an outside call, press {INT}. i Press {1}
(desired handset number). i When the handset 1
answered, press {ih} to complete transfer.
Example: When you make a conference call with
handset 1
During an outside call, press {INT}. i Press {1}
(desired handset number). i When the handset 1
answered, press {3} to establish a conference call.
Handset:
{j/OK} i "Handset Setup" i {>} i
"Registration" i {>} i "Register H.set"
i {>}
Base unit:
Press and hold {x} on the base unit for about 3
seconds, until the registration tone sounds.
Handset:
Wait until "Enter Base PIN" is displayed, then enter
the base unit PIN (default: "0000").
L When the handset has been registered successfully,
w will stop flashing.
{j/OK} i "Base Unit Setup" i {>} i Enter
"335". i "Cancel Handset" i {>} i Select the
handset(s) you want to cancel, by pressing the desired
handset number. i {j/OK} i "Yes" i {>} i
{ih}
Basic Operations
*2
*3
i {j/OK}
15