Table of Contents
Advertisement
Installing on a wall
When installing the HP 517 on a wall, ensure that the surface to which you attach the HP 517
and the fasteners you use can support at least 0.9 kg (2 lbs). Allow extra weight for cables.
1.
Hold the optional Unified Wired WLAN Walljack Table/Flush Wall Mount panel in a vertical
orientation against the wall where it will be installed. Mark two holes for the screws or
user-supplied wall anchors.
2.
If using wall anchors, drill two holes, typically 4.7 mm (3/16 inch) in diameter, and then
insert the anchors and tap them flush with the wall.
3.
Use the supplied two screws to loosely attach the mount panel to the wall.
4.
Run the required network cables through the top, bottom, or sides of the wall mount panel
allowing sufficient length for the cables to reach the not-yet installed HP 517.
5.
Tighten the screws to secure the mount panel to the wall.
6.
Place the mounting bracket, with the UP arrow pointing up, on the wall mount panel, and then
use four mounting screws to secure the bracket to the panel.
8
Installing the HP 517
Advertisement
Table of Contents
