Timer-Controlled Recordings; Programming Recordings With Showview - Panasonic DMR-ES30V Operating Instructions Manual

TIMER-controlled recordings

ShowView
8 3 5 4 2 - - - -
ENTER
:enter : access
0 - 9
RETURN
: correct : return
Timer recording
Name Date Start Stop
1 ARD 19.11. 10:30 11:30 SP ON
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
: select ENTER : store
CANCEL : delete RETURN
ShowView
Insert a video cassette with intact write-protection tab.
Press ShowView.
Enter the ShowView number using the number buttons.
Use
Confirm the ShowView number with ENTER.
In the Timer recording screen, check the start and end time and the VPS/PDC
signal.
If [- - -] is displayed under Name, use
1 / 3
VPS
PDC
- - - -
- - - -
- - - -
- - - -
Automatic SP/LP switching
- - - -
A: If the remaining tape time is not sufficient to start a programmed recording,
then the SP/LP function switches to the LP tape speed. This ensures that the
: return
entire programme is recorded. If the remaining time on the tape is also not
enough in LP mode, then the programme cannot be recorded in full.
An automatic switching to EP mode is not possible.
VPS/PDC function
If the television station sends VPS/PDC signals, the beginning and end of a
recording are synchronised with the current air time.
The programme start time must be set correctly to the start time given in the
magazine.
When recording in the NTSC system, the function may not work.

Programming recordings with ShowView

to delete a number.
Use , to select the recording mode [A, SP, LP, EP].
Save the programme using ENTER.
Press TIMER to switch the unit to timer standby mode.
The symbol lights up in the unit display.
.
to select the desired programme position.
VHS
37