During Initial Startup - JVC VR-N900U Startup Manual

Preparation

During Initial Startup

Perform language setting and automatic camera registration
when starting up this unit for the first time.
Before Starting Up.
● The DHCP setting is required for the IP camera beforehand.
Start up this unit first, then switch the camera on after
confirming that the [Auto Detect Setting] window is displayed.
● Refer to the user manual supplied with the camera for
instructions on how to specify the IP camera settings.
● By default, Time zone is set to GMT. Specify a Time zone
according to the region used. Refer to the INSTRUCTIONS on
how to specify a Time zone settings.
Keypad
[ZOOM IN/ENTER] Button
Starting this unit
1
Turn on the power switch at the rear panel.
● Doing so starts up this unit.
Selecting a language
The [Language Setting] screen appears when you start up this
unit for the first time. Select the language to use using the steps
below.
1
Select a language
● Use the [2/D] or [8/E] button to select a language.
2
Use the [SKIP] button to select [OK], followed by
pressing the [ZOOM IN/ENTER] button
● The AThe system is being set up.B message may appear
depending on the setting, and the system is automatically
rebooted.
Memo :
● Selecting [OK] changes the color of the [OK] characters from
brown to orange.
12
[KEY] Button
[SKIP] Button
Automatic Registration of Cameras
After you have started up this unit for the first time and finished
selecting a language, the [Auto Detect] screen appears.
1
Check to ensure that [Auto Detect] is selected,
followed by pressing the [ZOOM IN/ENTER]
button
● The APlease wait...B message appears.
Memo :
● The characters of the selected item switches to orange color.
Memo :
● In the case of VR-N900U, the analog input appears on the [Auto
Detect] screen from the start as the AAnalog-inB network
encoder (IP video server) of A192.168.201.12B.
2
Check to ensure that the camera is detected
● After the message disappears, a list of detected cameras
is displayed.
● If all the cameras are not detected, press the [Auto Detect]
button again. If doing so does not solve the problem,
check the connection with the cameras and the IP
address of the cameras.
3
Replace the detected camera accordingly in
sequence
Use the [SKIP] button to select the Sort button, followed by
pressing the [ZOOM IN/ENTER] button to sort the order of the
detected cameras in sequence.
● The Sort button allows you to perform [IP] sort, [MAC]
sort, [CH] sort, [MAKER] sort, or [MODEL] sort.
● After using the [SKIP] button to select the list, followed by
using [2/D] or [8/E] to select a camera, use the [SKIP]
button to select [Up] or [Down], and press the [ZOOM IN/
ENTER] button to change the sequence of the cameras.
● Deselect the check box of any camera that you are not
using.