Yamaha RX-V2065 Owner's Manual page 47

Menu/Submenu
Function Setup
HDMI
HDMI Control
Standby Through
Audio Output
Resolution
Aspect
Display
Dimmer
Front Panel Display Scroll
GUI Position
Volume
Adaptive DRC
Max Volume
Initial Volume
Input Rename
Zone
Zone2 Max Volume
Zone2 Initial Volume
Zone3 Max Volume
Zone3 Initial Volume
Network
IP Address
MAC Address Filter
Network Standby
Information
DSP Parameter
Memory Guard
Sets various items for HDMI and display.
Sets various items for input sources.
Selects on or off of the HDMI control function when a component that supports
the HDMI control function is connected to the HDMI OUT 1 jack of this unit.
Selects on or off of output of HDMI signals input from the HDMI 1-4 jacks or
HDMI IN (VIDEO AUX) jack to the active HDMI OUT jack(s) when this unit is
on standby.
Selects this unit or a component connected to the HDMI OUT 1 jack of this unit
for reproducing sound signals.
Sets resolution of the HDMI output that is converted from analogy visual input
signals.
Set an aspect ratio of images reproduced by HDMI signals converted from analog
video input signals.
Sets items for a video monitor or the front panel display.
Sets brightness of the front panel display.
Selects the way to display characters on the front panel display.
Adjusts top and bottom positions of the GUI screen displayed on the video
monitor.
Sets items for volumes.
Adjusts the dynamic range (difference between the maximum volume and the
minimum volume) in conjunction with the volume level.
Sets the maximum volume level so that the volume will not be accidentally
increased.
Sets the volume at the time this unit is turned on.
Changes input source names to be displayed on the GUI screen or the front panel
display.
Sets the maximum volume level and initial volume level of Zone2/3.
Sets the maximum volume level of Zone2.
Sets the volume level of Zone2 applied when this unit is turned on.
Sets the maximum volume level of Zone3.
Sets the volume level of Zone3 applied when this unit is turned on.
Sets items for network features.
Sets the network parameters (IP address, etc) manually.
Sets MAC address filter to restrict access to this unit via LAN.
Selects whether or not to accept the commands via network when this unit is on
standby.
Displays network information.
Sets parameters for the sound field programs.
Protects some settings against accidental alteration.
Operating various settings for this unit (Setup menu)
Function Page
49
49
49
49
49
50
50
50
50
50
50
50
50
51
51
51
51
51
51
51
51
51
51
51
52
52
52
55
45
En