Other Options - Panasonic KX-TG1850ALT Operating Instructions Manual

TG1850AL(e).book Page 30 Monday, December 6, 2004 9:10 PM
Base Unit Settings
list to the phone number "123-456-7890",
the unit dials "456-7890".
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
30).
4
Select "Call Options", then press
,.
5
Select "ARS Settings", then press
,.
6
Select "Area Code", then press ,.
7
Select an area code location (1-4), then
press ,.
L If the location already contains an
area code, the code is displayed.
8
Enter an area code (5 digits max.), then
press ,.
9
Press {ih}.
Setting call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up
to 6 phone numbers to be restricted, and
select which handsets will be restricted.
Storing area codes here will prevent the
restricted handsets from dialling any phone
number in that area code. If a restricted
number is dialled, the call will not be
connected and the restricted number will
flash on the display.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
30).
4
Select "Call Options", then press
,.
5
Select "Call Restrict", then press
,.
30
6
Set which handsets will be restricted by
pressing the desired handset number.
L All the registered handset numbers
will be displayed.
L Flashing numbers indicate call
restriction is turned on for the
corresponding handset.
L To turn call restriction off for a handset,
press the number again. The number
will stop flashing.
7
Press ,.
8
Select a memory location, then press
,.
L If the memory location already
contains a restricted number, the
number is displayed.
9
Enter the phone number or area code to
be restricted (8 digits max.), then press
,.
L To erase a restricted number, press
{C/T}.
10
Press {ih}.

Other options

Changing the base unit PIN
(Personal Identification Number)
For security, the base unit PIN must be
entered when changing certain settings. The
default PIN is "0000".
Important:
L If you change the PIN, please make note
of your new PIN. The unit will not reveal
the PIN to you. If you forget your PIN,
consult your nearest Panasonic service
centre.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it.