Table of Contents
Advertisement
Turning the power on/off
Power on
Press {ih} for about 1 second.
L The display will change to the standby
mode.
Power off
Press {ih} for about 2 seconds.
L The display will go blank.
Setting the date and time
Important:
L Confirm that the AC adaptors are
connected.
L Ensure that w is not flashing.
1
Press $ (centre of joystick).
2
Select t, then press , 2 times.
3
Enter the current day, month and year by
selecting 2 digits for each.
Example: 17 May, 2004
Press {1}{7} {0}{5} {0}{4}.
L If you make a mistake, use the joystick
to move the cursor, then make the
correction.
4
Enter the current hour and minute by
selecting 2 digits for each.
5
Press / repeatedly to select 12- or
24-hour time entry.
L 24-hour time entry is selected when
neither "AM" nor "PM" are displayed.
Example: 3:30 PM
Press {0}{3} {3}{0}, then press /
repeatedly until "03:30 PM" is
displayed.
6
Press ,.
7
Press {ih}.
Note:
L If a power failure occurs, set the date and
time again.
Preparation
11
Advertisement
Table of Contents
