Caller ID service. Charge the batteries for about 7 hours before initial use. Please read these Operating Instructions before using the unit and save them for future reference. Digital Cordless Phone Operating Instructions KX-TCD430AL Model No.
TCD430AL(E).book Page 2 Tuesday, March 30, 2004 5:27 PM Table of Contents Preparation Accessory information ....3 Important information ....4 Location of controls .
TCD430AL(E).book Page 3 Tuesday, March 30, 2004 5:27 PM Preparation Accessory information Thank you for purchasing a new Panasonic digital cordless phone. Dear Purchaser, You have acquired a product made in compliance with the digital enhanced cordless telecommunications (DECT) standard. DECT technology is characterized by high-security protection against interceptions as well as high-quality digital transmission.
TCD430AL(E).book Page 4 Tuesday, March 30, 2004 5:27 PM Preparation Important information General L Use only the power supply included with this product, noted on page 3. L Do not connect the AC adaptor to any AC outlet other than a standard 220–240 V AC outlet.
Page 5
TCD430AL(E).book Page 5 Tuesday, March 30, 2004 5:27 PM Instructions to customer Installation Attached to this telephone is an approval label. This label is evidence that it is a “Permitted Attachment” which has been authorised to be connected to your telephone service. Conditions relating to connection and operation of this Permitted Attachment are contained in Telecommunications General By-Law 220 (5).
Page 6
Warning: This cordless telephone system does not incorporate provision for secrecy of conversations. Appropriately tuned radio equipment and other cordless telephone systems in close proximity may be used by a third party to monitor and possibly interrupt conversations in progress when...
TCD430AL(E).book Page 7 Tuesday, March 30, 2004 5:27 PM Location of controls Handset A Receiver B Display C {k} (Phonebook) D {C} (Talk) E Navigator L{e}{v}: To search for the desired item in the setting menu, caller information or phonebook. L{>}: To select the desired item or move the cursor to the right.
TCD430AL(E).book Page 8 Tuesday, March 30, 2004 5:27 PM Preparation Connections Hooks LIN E (220–240 V, 50 Hz) Note: L If the handset is not charged, you cannot make or answer calls. L Never install telephone wiring during a lightning storm. L The AC adaptor must remain connected at all times.
If 074 flashes even when the handset batteries have been fully charged, both batteries must be replaced. Important: L Please use only the Panasonic batteries, Preparation noted on page 3. L Use only rechargeable batteries. If you install non-rechargeable batteries and start charging, the batteries may leak electrolyte.
TCD430AL(E).book Page 10 Tuesday, March 30, 2004 5:27 PM Preparation Wall mounting Hook Hooks Note: L Make sure the screws are securely fastened to the wall. L Use the following wall template to position the screws before drilling. Setting the time and date Important: 8 cm L Confirm that the AC adaptor is connected.
TCD430AL(E).book Page 11 Tuesday, March 30, 2004 5:27 PM Telephone Making calls Lift the handset and dial the phone number. L To correct a digit, press {C}, then enter the correct number. Press {C}. When finished talking, press {ih} or place the handset on the base unit.
TCD430AL(E).book Page 12 Tuesday, March 30, 2004 5:27 PM Telephone displayed. To turn off key lock, press {j} for about 2 seconds. Note: L Emergency calls cannot be made until key lock is turned off. L Key lock is turned off when the handset is turned off.
TCD430AL(E).book Page 13 Tuesday, March 30, 2004 5:27 PM Phonebook Storing phone numbers and names Up to 20 phone numbers can be stored in the phonebook for quick access. Press {j} 2 times. Enter a phone number (24 digits max.). L Each number stored in the phonebook will be given an index number (01–20).
TCD430AL(E).book Page 14 Tuesday, March 30, 2004 5:27 PM Telephone Making calls using the phonebook Before using this feature, store the desired phone numbers and names into the phonebook (page 13). Press {k}. Press {e} or {v} repeatedly to display the desired entry.
TCD430AL(E).book Page 15 Tuesday, March 30, 2004 5:27 PM Caller ID service Important: L This unit is Caller ID compatible. To display the caller’s phone number, you must subscribe to Caller ID service. After subscribing to Caller ID, this unit will display caller information.
TCD430AL(E).book Page 16 Tuesday, March 30, 2004 5:27 PM Telephone Example: *1 Shown when this call has already been viewed or answered. Press {C} to call back the displayed party. Note: L When no calls have been received, the display will show “NO ITEM”. Editing a caller’s phone number before calling back Press {e} or {v} repeatedly to display...
TCD430AL(E).book Page 17 Tuesday, March 30, 2004 5:27 PM Useful Telephone Settings Guide to handset settings For your reference, a chart of all items which can be customised for the handset is printed below. Details of each item can be found on the corresponding pages. To enter the 2nd menu, first press {>}.
TCD430AL(E).book Page 18 Tuesday, March 30, 2004 5:27 PM Useful Telephone Settings Handset settings Time alarm An alarm will sound for 3 minutes at the set time once or daily. “ONCE”: The alarm will ring only once. “REPEAT DAILY”: The alarm will ring at the set time everyday.
Page 19
TCD430AL(E).book Page 19 Tuesday, March 30, 2004 5:27 PM Press {v} repeatedly to display the desired item, then press {>}. Press {v} repeatedly to select the desired setting from “RING TYPE 1” to “RING TYPE 20”, then press {>}. Press {ih}. Note: L If you select one of the melody ringer types, the ringer will continue to sound for...
TCD430AL(E).book Page 20 Tuesday, March 30, 2004 5:27 PM Useful Telephone Settings Press {v} repeatedly to display “SETTING HS”, then press {>}. Press {v} repeatedly to display “DISPLAY OPT”, then press {>}. Press {v} repeatedly to display “TALK MODE”, then press {>}. Press {v} repeatedly to select the desired setting, then press {>}.
Page 21
L If you change the PIN, please write down your new PIN as the unit will not reveal the PIN to you. If you forget your PIN, consult your nearest Panasonic service centre. Press {j}. Press {v} repeatedly to display “SETTING HS”, then press {>}.
L If you change the PIN, please write down your new PIN as the unit will not reveal the PIN to you. If you forget your PIN, consult your nearest Panasonic service centre. Press {j}. Press {v} repeatedly to display “SETTING BS”, then press {>}.
TCD430AL(E).book Page 23 Tuesday, March 30, 2004 5:27 PM Select the desired setting by pressing {1} for 700 ms or {2} for 100 ms. Press {>}, then press {ih}. Setting pause length Press {j}. Press {v} repeatedly to display “SETTING BS”, then press {>}. Press {3}.
TCD430AL(E).book Page 24 Tuesday, March 30, 2004 5:27 PM Useful Telephone Settings Press {C}. Press {>}, then press {ih}. Storing emergency numbers This feature determines which phone numbers may be dialled while the call bar feature is turned on. A total of 4 emergency numbers (memory locations 1–4) can be stored.
TCD430AL(E).book Page 25 Tuesday, March 30, 2004 5:27 PM Multi-unit Operation Operating additional units Additional handsets Up to 6 handsets can be registered to a single base unit. Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call.
TCD430AL(E).book Page 26 Tuesday, March 30, 2004 5:27 PM Multi-unit Operation L If you changed PIN, enter it (page 22). Press {>}. L When the handset has been registered successfully, a confirmation tone will sound, and w will stop flashing. Note: L If all registered handsets start ringing in step 5, press {x} to stop, then start again...
TCD430AL(E).book Page 27 Tuesday, March 30, 2004 5:27 PM Setting all or selected handsets to ring You can select one of 3 methods to determine how the handsets ring for incoming calls. − “1”: All handsets will ring. − “2”: Selected handset(s) will ring. −...
TCD430AL(E).book Page 28 Tuesday, March 30, 2004 5:27 PM Multi-unit Operation Intercom between handsets You can make intercom calls between 2 handsets in the same radio cell. Example: When handset 1 calls handset 2 Handset 1: Press {INT} and {2} (desired handset number).
TCD430AL(E).book Page 29 Tuesday, March 30, 2004 5:27 PM Useful Information Troubleshooting If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
(page 26). L You entered the wrong PIN number. If you forget your PIN, consult your nearest Panasonic service centre. L Locate the handset and the base unit away from other electrical appliances. Technical information...
TCD430AL(E).book Page 31 Tuesday, March 30, 2004 5:27 PM Index Index A Additional base units: 25 Additional handsets: 25 All handsets to ring: 27 Selected handsets to ring: 27 Answering calls: 12 Auto talk: 12 B Base unit Cancelling: 26 Guide to settings: 22 PIN: 22 Resetting: 24...