Panasonic HDC-TM10 Operating Instructions Manual page 124

Problem
Some playback images
are skipped
automatically.
Scene does not play back
to the end.
Although this unit is
correctly connected to a
TV, images cannot be
seen.
The images are squeezed
horizontally.
Scenes cannot be
deleted.
If the SD card is inserted
in this unit, it is not
recognised.
If the SD card is inserted
in another device, it is not
recognised.
Colour or brightness of
the image changes, or
you may see horizontal
bars in the image.
Object seems to be
warped.
124
VQT2D32
≥ Playback of (Intelligent scene selection) is set. Return
to normal playback. (l 68)
≥ Please read the operating instructions of your TV and
select the channel that matches the input used for the
connection.
≥ Change the [TV ASPECT] setting to match the aspect ratio
of the TV.
≥ Change the setting of the unit depending on the cable
connecting to the TV. (l 84, 87)
≥ Release the protect setting. (l 77)
≥ Any scenes/still pictures where the thumbnails are
displayed as cannot be deleted. If the scenes/still
pictures are unnecessary, format the media to erase the
data. (l 83) Please be aware that if a media is formatted
then all the data recorded on the media is erased and
cannot be recovered. Back up important data on a PC, disc
etc.
≥ If the SD card is formatted on a PC, it may not be
recognised by this unit. Use this unit to format SD cards.
(l 83)
≥ Check that the device is compatible with the capacity or
type of SD card (SD Memory Card/SDHC Memory Card)
that you inserted. Refer to the operating instructions of the
device for details.
≥ Colour or brightness of the image may change, or you may
see horizontal bars in the image when the object is
recorded under fluorescent light, mercury light or sodium
light, etc., but this is not a malfunction. Record in auto mode
or set the shutter speed to 1/100 in areas where the power
supply frequency is 50 Hz, or 1/125 in areas of 60 Hz.
≥ Object seems to be warped slightly when the object moves
across the image very fast, but this is because the unit is
using MOS for the image sensor. This is not a malfunction.
Check points