Panasonic TH-32LR11UK Operating Instructions Manual page 36

Options Adjustments
Item
Off
You can set the power-on delay time of the displays to reduce the power load, when you press POWER switch
to turn on the multiple displays that are set together.
Set each display's setting individually.
Off:
1 to 30 (sec.): Set the power-on delay time (second).
Power On Screen
Notes:
Delay
• During this function is working, the power indicator is blinking green.
• This function also works when the power recovers from failure or after plugging off and in again the power
cord.
After you unplug and plug the power cord in while the unit is in standby mode and also the power is being
supplied to a terminal board, the unit will start supplying the power to the board with time delay according
to the setting.
The power indicator lights up red fi rst and it turns orange when the power starts being supplied to the
board.
Off:
On:
The clock is displayed at the lower left of the screen when
Clock Display
Note: When "PRESENT TIME SETUP" is not set, the clock is not displayed even if "Clock Display" is "On"
Sets All Aspect mode (advanced aspect setting) or default aspect mode.
With each press of
Off:
On:
All Aspect
Aspect mode of each setting is as follows:
(Example: HD signal)
Off
On
Slot1
Serial Slot
Selects the slot which communicates serial.
Select
Note: The setting of an external command can be set only from the fi xed serial terminal. (see page 11)
Normalization
When both main unit buttons and remote control are disabled due to the "Button lock", "Remocon User level" or "Remote
ID" adjustments, set all the values "Off" so that all the buttons are enabled again.
Press the button on main unit together with
– /▼
"SHIPPING" menu is displayed and the lock is released when it disappears.
36
1 2 3.... 30
The display will be turned on at the same time as POWER switch is pressed.
After pressing POWER switch, the display will be powered on with time delay depending on this
setting.
Not display the clock.
Display the clock.
10:00
(see page 25)
button, the aspect changes in the selected mode.
Default aspect mode
All Aspect mode
4:3 H-FILL ZOOM FULL JUST
4:3 (1) 4:3 (2) 4:3 Full Zoom1 Zoom2 Zoom3 16:9 14:9 Just1 Just2
Slot2 Slot3
button on the remote control and hold for more than 5 seconds. The
Adjustments
button is pressed.