Panasonic TH-32LR11UK Operating Instructions Manual page 35

Item
Off
Locks the input switch operation.
Notes:
• Only the adjusted signal is displayed (see page 13).
• Signal can be displayed when the Terminal board is installed.
INPUT lock
• Input switch can be used when this is set to "Off".
• In two screen display mode, if anything other than "Off" is set, the value will be fi xed as the value input in
the single screen display mode.
• When a dual input terminal board is attached, A or B is displayed depending on the selected input signal.
(Ex. INPUT1A, INPUT1B)
Off
Off: All the buttons on main unit can be used.
MENU&ENTER: Locks
On: Locks all the button on main unit.
Button lock
Sets Button lock with the unit buttons in the following procedure.
Off: Press
MENU&ENTER: Press
On: Press
Off
Off:
User1:You can only use
Remocon User level
User2: You can only use
User3:Locks all the buttons on remote control.
Off:
On:
Notes:
Advanced PIP
• When "INPUT lock" is "On", you cannot use all the two screen display functions.
• ,
Enable:
Off-timer function Disable: Disables the "Off-timer function".
Note:
Normal
Sets the power mode of the unit for when the power recovers from failure or after plugging off and in again.
Normal: Power returns in as the same state as before the power interruption.
Initial Power Mode
Standby: Power returns in standby mode. (Power Indicator : red/orange)
On:
Note:
Sets panel ID number when panel is used in "Remote ID" or "Serial ID".
Set value range: 0 - 100
ID select
(Standard value: 0)
The setting of this menu is valid only when using ID remote control.
Off:
Remote ID
On:
Sets the panel ID Control.
Off:
Serial ID
On:
Off
Off:
Auto: Power is transmitted to the slot power only when main power is on.
Slot Power
On:
Note: In some cases, power is transmitted to the slot power when main power is on or in the standby state
PC INPUT1 INPUT2
MENU&ENTER On
and
MENU
ENTER/
four times Press
+/▲
four times Press
■
ENTER/
four times Press
– /▼
ENTER/
User1 User2
You can use all of the buttons on the remote control.
, ,
button on the remote control.
Sets normal two screen display mode (see page 17).
Sets Advanced PIP mode (see page 18).
buttons are unavailable during Advanced PIP mode operation.
Enables the "Off-timer function".
When "Disable" is set, the Off-timer is cancelled.
Standby On
Power returns in power On. (Power Indicator : green)
When using multiple displays, "Standby" is preferred to be set in order to reduce a power load.
Disables ID remote control functions. You can use normal remote control operations.
Enable ID remote control functions.
Disables external control by the ID.
Enables the external control by the ID.
Auto On
Power is not transmitted to the slot power.
Power is transmitted to the slot power when main power is on or in the standby state.
regardless of the slot power setting.
Adjustments
INPUT3
buttons on main unit.
■
four times Press four times Press
– /▼
INPUT
four times Press
+/▲
four times Press four times Press
+/▲
■
User3
, , , buttons on the remote control.
Options Adjustments
■
ENTER/
four times Press
ENTER/
INPUT
■
ENTER/
■
35